![]() ![]() The OUT pin is the main output of the board and indicates whether the switch is active.Įach of these outputs can source or sink up to 25 mA.The GOOD pin indicates the presence of a valid RC signal (10–330 Hz pulse rate, 0.5–2.5 ms pulse width).Status information is also provided on two output pins: The RC switch provides feedback about what state it is in via a yellow indicator LED. This compact unit measures 0.4″ × 0.4″ and weighs 0.3 g (0.01 oz) without the included header pins. A safe-start feature reduces the likelihood of unexpected activation. By default, the threshold is approximately 1700 μs, with switch activation occurring above the threshold (longer pulses), but the switch has a learning mode that allows you to change the threshold and the activation direction. The RC switch measures the width of incoming RC pulses and compares it to a user-configurable threshold (with ☖4 µs of hysteresis) to decide whether to turn the output. The board can be powered by whatever digital system is reading the output, or it can be powered from the RC receiver if you bridge the surface-mount jumper on the bottom of the board that connects VRC to VCC. The board requires a 2.5–5.5V power source supplied to VCC. ![]() Two digital outputs indicate the presence of a valid signal and whether the switch is on or off. For example, this module can be used to convert unused RC receiver or servo controller channels to simple high/low signals that can control LEDs, MOSFETs, or relays, or it can serve as a simple interface between RC systems and microcontrollers that do not have the necessary resources for decoding hobby RC servo pulses. The Pololu RC switch with Digital Output can be used with standard hobby radio control systems for radio control switch applications or simple interface applications. The activation threshold and direction are configurable, and a safe-start feature reduces the likelihood of unexpected activation. One output indicates the presence of a valid RC signal, and the other indicates whether the switch is active. This RC switch converts hobby radio control pulses to digital on/off signals for use in RC switch and simple RC adapter applications. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |